How to enable Full Screen?

In the Multicam 5.3 or higher version. it support Full screen function mode. but it require your video card can support Overlay mode.

Enable Step:
Notice: After enable directdraw overlay this function, you need to save and exit the main program, go back to windows desktop
wait for 1 min.  And Rerun the software to make it work.

1	Go to Main Screen   Stop All monitoring first. and Stop all network services
2	Go to config button go to System configuration
3	Make sure Enable Directdraw Overlay is enabled Click OK to finish.
4	Exit the Main system software go back to Desktop. Wait for 1 min.
5	Run the Main system software again to make the full screen function active.
6	Press "F" from the keyboard to switch between full screen mode, and normal mode.