|
|
| 1 | Open Internet Explorer |  |
| 2 | Type Address: 192.168.1.1 |
 |
| 3 | Security Login will Popup No username type Admin Click OK |
 |
| 4 | You should see Main Page Go to
Status on the top tab.
Go to top right corner with Orange Color Tab -- Call Advanced ---> scroll to right to see it. Click it |
 Click Picture to enlarge if you cannot see clearly. |
| 5 | Now, you are in the Advance section. Go to the Filter page Scroll down and find Block WAN Request: Click Apply button to confirm changes.
If you see this page different than yours. Please click Here to check update |
 Click Picture to enlarge if you cannot see clearly. |
| 6 | Go to Forwarding Page
Type Port number as picture present. 80 to 80 v v 192.168.1.??? v change ??? to your DMRS system's IP address. You need to forward Port 80 to 80 -- for Webcam Remember scroll down to click Apply button to confirm changes. |
 Click Picture to enlarge if you cannot see clearly. |
| 7 | Congratulation, You just finish setting on
the Linksys Router. Now, we need to config your Multicam Webcam Server to pass thru the signal. |
|
| 8 | Open Multicam Program on the Desktop,
|
 Or, you can go Start -> Programs -> Multicam -> Multicam xxxxx System to Open the program |
| 9 | Stop All Monitoring First, Then, go to Network button as circle Red. Click it to Uncheck Webcam Server first. If it is uncheck, go to next step. |
 |
| 10 | Then, go to Network button again, Enable Webcam Server (Check it)
|
|
| 11 | It should pop up this window. Go to Server Setup Button
|
 |
| 12 | Click AutoFind If auto find is not match with your WAN IP address, please change to your WAN IP address. Click OK when Finish, then click Execute! to enable Webcam Server. |
 |
| 14 | Now, all done. You can try it now. | |
| 15 | Go to Internet Explorer | |
| 16 | Type your Webcam address in the address bar, You should get your webcam page. |
 |
| Page Update for Newer Linksys Router, you might see the page differently
Go Security -> Filter |
 |
|
| Page Update for Newer Linksys Router, you might see the page differently
Go Application & Gaming-> Port Range Forwarding
You need to forward Port 80 to 80 -- for Webcam |
 |
|
